|
|
|
|
|
|
|
|
|
|
|
|
|
|
Keep your Quik Drive auto-feed screw driving system in ideal condition with these Simpson Strong-Tie? replacement parts.
|
The WBSK workbench and shelving hardware kit provides the connectors and connector fasteners to build a workbench or shelving unit. The kit features the Simpson Strong-Tie? Rigid Tie? RTC2Z corner connector that makes it easier to make strong and durable corner connections with 2 x 4 lumber using no angle cuts or bolts. Each kit contains enough RTC2Z connectors to construct one workbench. Two kits are necessary to build a four-shelf unit. With the WBSK kit, a professional quality project can be customized and completed in a couple of hours.
|
Bearing plates give greater bearing surface than standard-cut washers and help distribute the load at these critical connections. The LBPS are bearing plates that offer increased flexibility while meeting the latest requirements of the code for 2 x 4 and 2 x 6 walls. The slotted hole allows for adjustability to account for bolts that are not in the middle of the sill plate.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bearing plates give greater bearing surface than standard-cut washers and help distribute the load at these critical connections. The LBPS are bearing plates that offer increased flexibility while meeting the latest requirements of the code for 2 x 4 and 2 x 6 walls. The slotted hole allows for adjustability to account for bolts that are not in the middle of the sill plate.
|
The HTT is a high-strength solution for resisting tension loads in post-pour, wood-to-concrete connections. This heavy, single-piece formed tension tie is fastened with nails or Strong-Drive? SD Connector screws. The HTT has a four-ply formed seat and a design without rivets that does not require washers.
|
The SS is designed to reinforce notched, vertical studs in construction. This stud shoe is used to strengthen a wall stud that has a large hole drilled through it, typically to accommodate a plumbing waste line. The SS installs over the outside diameter of the pipe and is used as part of a total member replacement in structural applications.
|
|
|
|
|
|
|
|
|
|
|
|
|
The CNW is designed to connect threaded rods to one another and to anchor bolts. These coupler nuts are designed to exceed the specified minimum tensile capacity of the corresponding bolts and threaded rod. All CNW coupler nuts feature a positive stop to help ensure even threading into each end of the nut and a Witness? hole as a means to verify when rods are properly installed.
|
|
|
